Passive POE cable Splitter and Injector for 30M

This device provides a low cost solution for delivering power over the network cable. This scheme allows power
to be carried on 10/100 networks over the spare, unused pairs of a CAT5, CAT5E, or CAT6 Ethernet network cable.
The source power could be the power supply that came with the wireless access point, IP video surveillance
camera, etc. or it might be another power supply.
 

This set contains a very cost effective injector and breakout or splitter component. The injector inserts the DC
voltage at the source location into the injector plug. The DC voltage is then carried over the spare pairs of the
10BASE-T or 100BASE T network cable. The breakout or splitter extracts the DC voltage from the network cable
onto the splitter jack. This eliminates the need for an AC power outlet nearby any equipment being installed in
ceilings, on outside walls or other locations, where power outlets are not conveniently installed. Under the right
conditions, with standard PoE injectors, power may be carried over a certain distance limitation of a single network
cable run.

Application:

Complete set for wide range of network products such as Access Points, Routers, IP cameras, modems,

WRAP boards and other devices using passive POE injection.

Data:

Data Pins 1,2,3,6

connected by them.